May. 17, 2020
Edible oil filling machine is the first equipment for packaging edible oil products, and also the key to maintaining the competitive development of the edible oil products market. With the passage of time, the types of edible oil products are becoming more and more abundant, and the packaging forms of the products are also changing. But no matter how the application of an edible oil filling machine is irreplaceable. Encouraged by science and technology, the technical performance of the edible oil filling machine has been greatly improved, especially in the issue of filling accuracy, there are strict control and improvement. However, in addition, there are many common problems that require cooking oil filling machine suppliers to operate the edible oil filling machine, pay more attention to control the emergence of problems.
First, after the edible oil filling machine is closed for use, the phenomenon of dripping occurs. After the production of the edible oil filling machine is completed, the phenomenon of dripping occurs afterward, and it should be operated from the following aspects:
1. Check whether the nozzle of the filling nozzle is damaged or not. You can take out the filling nozzle to repair the opening. The diameter of the opening should be less than 7.5mm. After repairing the aperture, smooth the orifice plane on the sandpaper.
2. Check whether the ball valve in the filling head is damaged. Replace the ball valve if damaged.
Second, after cranking the edible oil filling machine, the crank does not operate normally. What should I do?
The upper fixing rod of the edible oil filling machine is lowered. When the syringe pushes the liquid, the inner and outer tubes are firmly fixed, which prevents the crank from rotating. If the inner and outer tubes are not clean and stuck when the syringe is assembled, the syringe needs to be disassembled and cleaned. Observe that the injection system is not installed in the bearing. To prevent it from working properly, it must be reinstalled.
Vegetable Oil Filling Machine
Third, the vegetable oil filling machine has a faulty capacity error, or a large capacity error, what kind of adjustments need to be made?
There is air in the liquid pipe of the edible oil filling machine, press the footswitch to exhaust. The inlet pipe is not tightly sealed and there is air leakage, and the connection pipe is clamped. Operation or filling speed is too fast, slow down appropriately. The liquid level of the liquid tank is low, and the liquid level should be 1.52 meters. When filling large sizes, the feed tank has insufficient refilling, resulting in an unstable liquid level. You can increase the refilling amount or re-close the ball valve above the filling head to reset the filling time (extended).
How to carry out daily maintenance and maintenance:
1. Always keep the equipment clean, especially for the electrical appliances on the electric panel, it should be protected from moisture and dust, and it is forbidden to change the program of the inverter and the program controller at will.
2. The power supply voltage should be stable and not exceed ± 15%. The material temperature should be maintained at 10 ℃ ～ 40 ℃, the ambient temperature should be maintained at 5 ℃ ～ 40 ℃, and the temperature should be maintained at 5 ～ 95% PH.
3. The flowmeter used in this machine is a precision instrument. Therefore, the oil must be filtered accurately before filling.
4. The power supply and oil inlet valve should be turned off after the unfinished work is completed.
5. Pay attention to the cleanliness of the infrared sensor, and often wipe it clean with clean cotton. It is strictly forbidden for any object to be close to the sensor during the work. There must be no strong light direct or reflected on the sensor, otherwise, it will prosper and malfunction.
6. Regularly add cylinder lubricating oil to the pneumatic triplet.
7. When the machine is not used for a long time, all parts should be wiped clean and covered with plastic or tarpaulin to prevent dust.