Home >> News

[Liquid Filling Machine] What Are The Precautions For Safe Operation?

Jan. 04, 2020

The liquid filling machine is a machine for filling oil. It can fill carbonated beverages, sodas, sodas, and other aerated beverages, It can also be used for filling edible oil, pure water and other non-steam beverages. The juice beverage filling machine is filled under the pressure of the bottle is lower than the atmospheric pressure. It is suitable for liquids of various viscosities, such as oils, syrups, and fruit wines.

Liquid Filling Machine

Liquid Filling Machine

Using liquid filling machine china for beverage filling can greatly improve the filling efficiency, but you need to pay attention to safety when operating the machine.

Before use, test operation is required. By observing whether the three-phase motor is running in the correct direction, the pressure of the filling machine is normal, whether the motor and bearings are operating normally, and whether lubrication is required, it is also necessary to pay attention to the solidity of each part of the beverage filler Whether the pieces are loose.

When the magnetic pump liquid filling machine passes the inspection before use, it can be used. It is necessary to pay attention to whether the safety equipment functions normally during use. Before reopening after each shutdown, you need to check the water tank, chain plate, conveyor belt, lid storage box, etc. for any abnormality. At the same time, pay attention to whether the water source, power supply and gas source are connected. Power QF, power indicator light is on, fault indicator and emergency stop indicator are not on before you can press the start button on the control box and the start switch at the filling place to start the overall operation of the machine. Press the stop button at the installation place and the control box, and the main power should be turned off after stopping.

In the entire set of juice beverage filling machines, the operation control box is used to control the beverage filling machine. In the past, it was generally designed as a large-sized box. This is mainly for the sake of safety. The operation control will not cause safety accidents due to the performance problems of the operation control box.

1. In production, always observe the mechanical parts to see if the rotation and lifting are normal, whether there are abnormalities, and whether the screws are loose;

2. Check the ground wire of the equipment, and the contact requirements are reliable; clean the weighing platform frequently; check whether the pneumatic pipeline is leaking, and whether the air pipe is broken;

3. The reducer motor changes the lubricating oil (grease) every year, check the tightness of the chain, and adjust the tension in time;

4. If you stop using it for a long time, empty the materials in the pipeline;

5, do a good job of cleaning and sanitation, keep the surface of the machine clean, often remove the accumulation of material on the scale body, pay attention to keeping the inside of the electric control cabinet clean;

6. The sensor is a high-precision, high-sealing, high-sensitivity device. Impact and overload are strictly prohibited. Do not touch it during work. Disassembly is not allowed during non-repair.